During analytical stage a technique called stratification is used for controlling confounding variables. This technique involves sorting out the data into discernible groups.

ANOVA is based upon within group variance (i.e. the variance of the mean of a sample) and between group variance (i.e. the variance between means of different samples). The test works by finding out the ratio of the two variances mentioned above. (Commonly known as F statistic).

Since the data is normally distributed, 95% of the values lie with in the interval 70 to 90. This can be calculated as follows:

Interval= Mean ± ( 2 times standard deviation)
= 80 ± 2(5)
= 80 ± 10
= 70 & 90

The rest of the 5% are distributed symmetrically beyond 90 and below 70 which means 2.5% of the values lie above 90.

The relative risk (also known as risk ratio [RR]) is the ratio of risk of an event in one group (e.g., exposed group) versus the risk of the event in the other group (e.g., nonexposed group).

The odds ratio (OR) is the ratio of odds of an event in one group versus the odds of the event in the other group.

The dose-response curve plots the graph of the dose (drug concentration) versus the response. As doses increase, the response increment diminishes; finally, doses may be reached at which no further increase in response can be achieved. This relation between drug concentration and effect is traditionally described by a hyperbolic curve. When the x-axis is plotted in log scale, the graph yields a sigmoid curve.

Efficacy (Emax) and potency (EC50) can be derived from this curve. Emax is the maximal effect achievable, with increasing concentration of a drug. EC50 is the concentration of the drug, wherein half of the maximal effect is achieved.

When the graph is plotted using a log [response/1-response] against log dose, the sigmoid curve becomes a straight line (Hill plot). A graph that transforms from a straight line to exponential curve is mathematically incorrect. A graph that transforms from either a wash-in or wash-out exponential curve to a straight line comes from an initial set of data plotted against time, to a logarithmic transformation of the initial data set against time.

Key Point: While finding out confidence intervals, standard errors are used. Standard error and Standard deviation are two distinct entities and should not be confused.

For 99.7% confidence interval, you can find the range as follows:

Multiply the standard error by 3.

Subtract the answer from mean value to get the lower limit.

Add the answer obtained in step 1 from the mean value to get the upper limit.

The range turns out to be 1-13 mmol/L.

For a confidence interval of 68%, multiply the standard error with 1 and repeat the process. The range found for this interval is 3-11 mmol/L.

For a 95% confidence interval. Standard Error is multiplied by 1.96 which gives us the limit ranging from 3.08 to 10.92 mmol/L which could be approximated to 3-11 mmol/L.

Number needed to treat can be defined as the number of patients who need to be treated to prevent one additional bad outcome.

It can be found as:

NNT=1/Absolute Risk Reduction (rounded to the next integer since number of patients can be integer only).

Case control studies in particular are prone to recall bias, people who are suffering from COPD might sometimes relate the ailment to marijuana usage in past and hence contrary to the control group, they are more able to describe to what extent they have been using the drug in the past.

As recommended, all the doctors should make sure that there practice is based on evidence and thus it is paramount that the doctors learn to appraise the paper in a critical manner i.e. ability to detect any potential source of bias.

Detection Bias: Outcomes are more looked for in one group than the other.

Observer Bias: Subjectivity of observers regarding the outcome.

Publication bias: Not publishing the results of a valid study just because they are negative or uninteresting can be termed as publication bias.

Recall bias: Recall bias is specifically appropriate to the case control studies that is when ever the memories retrieved by the participants differ in accuracy.

Response Bias: The participants that filled out the response forms containing information that was going to be used for a trial, don’t represent the target population.

Since the data is normally distributed, 95.4% of the values lie with in 2 standard deviations from mean. The rest of the 4.6% are distributed symmetrically outside of that range which means 2.3% of the values lie above 2 standard deviations of the mean.

Selection bias is when randomisation is not achieved and is often a result of in efficient recruiting method.

Recall bias is specifically appropriate to the case control studies that is when ever the memories retrieved by the participants differ in accuracy.

Measurement bias can be characterized by gathering of information in a manner that is distorted.

When the participants of a research study are recruited from the hospitals rather than the general population, its called Berkson Bias.

Confounding bias is the major player here because in this case the effects of smoking can be masked behind and can be read as outcomes of lower socio economic status. This extraneous factor (Smoking), distorts the founding.